Taro figure #2 (Patreon)

Nearly all the pieces have printed for this one. Super excited about it. It was nearly impossible to hold her in the final pose but hopefully you get the idea. (I did chip her beak but that’s an easy fix ).

I printed the body in a clear pink so that I could keep the milkshake glass transparent. I’ll inject some white resin into the inside of it too. It’ll get buffed and sealed so it will be very shiny. Everything else will be primed and painted.

The tail will be embedded into the base so the rest of the sculpt can be suspended from it. The icecreams will be suspended on clear acrylic rods and the other treats will probably be strategically held up with thin wire attached to the base sculpt.

Original art by dreameleon