Diglet Pokeball (Patreon)

I have completely redesigned my Pokeball. This will be the base for every pokeball I do from now on.  The Hinge is now inside the ball and much larger.

I have also included a stand if it falls over. I added rocks to mine under the pokemon and it stays up fine.

For printing
FDM - Small or Large
The small size should work but you can do the large if you want.
.12 layer height
Tree supports.

Resin -  Small
This is tricky to print and took me a while to get just right.

You want the outside shells printed flat against the build plate. This took me so long because they were being warped and causing them not to fit.  Everything else print angled at 45. I used medium supports at 75% density

What Pokemon do you want in this ball next?