Home Creators Posts Import Register Favorites Logout

Downloads

Some files exceed the archive size limit and weren't saved: 12 files. Please note these limits are in place to keep this site running long term, without costing a fortune. You can favorite the creator though, certain milestones increase the limit.

Content

The All Terrain Scout Transport (abbreviated to AT-ST) was a scout and reconnaissance light walker of the Galactic Empire's All-terrain vehicle line. It consisted of an armored command and control cabin mounted on two gyro-stabilized legs and was utilized for battle line support, antipersonnel hunting and troop support. They were also commonly used to screen the flanks of larger assault walkers for major ground operations, during which they supported heavier walkers such as AT-ATs by eliminating pockets of resistance and clearing out denser terrain such as small canyons and cities along the path of a planned invasion route. (Wookieepedia)

Hi guys, this is the missing vehicle of last week. Sorry for the delay, it has taken me some time to fix the most challenging feature of this All Terrain Scout Transport: being able to stand upright and not fall over in slow motion in front of my eyes. So yep, I think I find it´s balance... It has some parts to print and an assembly guide is more than necessary to be able to put everything together.

I hope you like it (a very requested model by the way) and I look forward to your comments on how it goes.

Aitor aka Playaction.

Printing tips

It is very important to print the different pieces in the provided orientation to prevent undesirable fillings. No glue needed. No additional support is needed. Clean carefully the brim and supporting parts before assembling the model. You can follow this guide for print and assembly.

The recommended print resolution for this model is 0,2 mm layer height.

Keep in mind that there are two types of seats (files 3 and 4): The regular seat, to accommodate a figure of normal height and the Chewy seat, to accommodate the figure of Chewbacca, which is slightly taller.

Files

Comments

e c

I'm in love! That is freaking amazing! I have imagined what this would look and it has gone above and beyond my expectations!

StevenGeuel

Wow! Absolutely amazing! It was worth the wait! One of your best projects so far!

Minhad Setiawan

my printer is in service right now. I want to print this so bad

e c

Just printing this, and not sure about part 29.Bolt 1, doesn't look like the one in the instructions and the peg is to wide to go through the hole on part 27.Leg 4 and to short for the gap in part 30 Feet

Mike R

I'm having trouble printing LEG 3, it seems like the distance between the support/plate and the "wheel" is too large and i just get loose blobs of plastic there. Trying again slower but any tips here?

Riptide Oleary

I’m almost done printing, gonna need some pilots!!😉

GMC Entertainment

Absolutely gorgeous. I'm upscaling this to 105 percent so that my Kenner figures can fit in it. I've got the legs done so far, printing the head, cockpit, and a few of the guns now. Your vehicles are absolutely breathtaking and superior to anything on the market now.