RELEASE: Wolverine/Logan bust (Patreon)

Click here for the current Dropbox download link. 

Hello, hope everyone's having a good weekend! So here's a new one for you Supporter/Kingpin patrons: Logan/Wolverine. I've had this one on the backburner for a while now, and decided to finish him up.

Logan is a short and hairy dude, and I considered for a while to sculpt in the hair on his body (shoulders/back/chest), but I was a bit worried it might not print very well so in the end I decided against it, but if someone really wants sculpted back hair I'm sure I could oblige... :P

Information about printing

This is just a simple, straightforward bust in two parts so there's no magic that goes into printing him. No external supports needed. I'd give him a proper brim (pictured below) because the contact surface isn't huge, but if you know your prints have good bed adhesion then he should be all right.

Thank you for the continued support! I'll drop you guys a preview soon of what is up next, I'm not quite ready to reveal just yet!