Home Creators Posts Import Register Favorites Logout

Content

Hi lovely Patreons! This is the post for resources to accompany the "haunted drawers" tutorial.

The components I'm using are as follows:

Hyundai Super Silent 550W Air Compressor: https://www.amazon.co.uk/Hyundai-Electric-Compressor-Release-Fittings/dp/B07TJQZLSF

3x 12V 5-way, 2-position solenoid valves: https://s.click.aliexpress.com/e/_c3Wkz34P

3x Double-acting pneumatic cylinders (200mm stroke): https://s.click.aliexpress.com/e/_c4lXBp9t

You can either use a manifold: https://s.click.aliexpress.com/e/_c45GgUH5 (which incorporates multiple solenoids in a single block), or else use a simple splitter to share air between solenoids: https://s.click.aliexpress.com/e/_c4clp6wR

Air tubing: https://s.click.aliexpress.com/e/_c3mqivqj

Connectors: I use 8mm connectors and tubing throughout, but you can use whatever suits you. e.g. https://www.aliexpress.com/item/1005004503020999.html . You will probably need M5 thread for connecting to the cylinders, and 1/8" for connecting to the solenoid/manifold block. If you have any spare ports, you'll also need blanking plugs like these: https://s.click.aliexpress.com/e/_c3ocVBcn (unlike electrical circuits, you can't leave unused pneumatic ports open or else all the air will escape from the system!)

Kincony KC868-A6: https://www.aliexpress.com/item/1005004246120574.html This is the ESP32-based board I'm using. I've been using Kincony products for quite a while and I'm pretty impressed with the build quality compared to other dev boards, and this one also packs in 6 relay outputs, RS485, RS232, and LoRa! Not bad for £20... but you can use any other similar controller and a separate relay module to control the solenoid valves if you prefer.

You can access the additional resources at the following Google Drive link:

https://drive.google.com/drive/folders/1-bIzr0G3vmHbN2cHLv_EovGGqhWW9pAI?usp=drive_link

haunteddrawers.ino (code that's running on the ESP32)

Haunted_Drawers.aia (MIT App Inventor project for the Bluetooth phone app)

wiring.jpg (pneumatic/electronic wiring diagram)

Comments

No comments found for this post.