Home Creators Posts Import Register Favorites Logout

Content

Lots of electronic devices comes with RF remote controls - often small keyfobs, which send simple commands encoded as radio signals on either 315MHz or 433MHz radio frequency.

In this project, I use a cheap receiver with an Arduino (or ESP32 or other microcontroller) to receive and learn the commands sent when different buttons on a remote are pressed, then examine the data to identify and separate the control signal from the noise in the raw signal, and copy the timing/encoding used to clone the behaviour of the original device.

Having done that, I can then use a transmitter module (on the same frequency) to broadcast the signal to control the device directly from the Arduino instead, which allows them to be triggered from any other input, or from a network message or sensor. Perfect for, e.g. automating cheap fog machines or other stage effects in escape rooms, or creating backups or a "universal controller" to activate remote plug sockets which can control any fixture, or act as an override to release maglocks etc., but I'm sure you can think of many other uses!

I'm using the RF433Any library from: https://github.com/sebmillet/RF433any

The 433MHz RF modules I'm using are like this (but, as explained in the video, make sure you get ones that match the frequency of your device, and on a frequency that is permitted in your country): https://www.amazon.co.uk/DollaTek-Wireless-Transmitter-Receiver-Raspberry/dp/B07DJ2ZJXR

You can access the two code listings for capturing the signal, and then sending it again from a serial message at the following Google Drive link: https://drive.google.com/drive/folders/1C3Kt8S8H0cwXmJmLAkymYnrIhju4rtC4?usp=sharing

Enjoy, and I wish you all a very Happy Christmas, and a Peaceful New Year :)

xxx

Files

Automate any wireless device

Lots of electronic devices comes with remote controls - often designed as small keyfobs, these generally broadcast commands encoded as radio signals, broadcast on either 315MHz or 433MHz radio frequency. In this video, I'll explain how you can use a cheap RF receiver with an Arduino, ESP32, or other microcontroller to receive and learn the commands sent from these remote controls, identify and separate the control signal from the noise in the raw signal, and copy the encoding protocol used to perfectly clone the original. You can then re-broadcast that signal to add automation or "smart" control to any dumb device, such as triggering them via a network message or sensor. Perfect for smart homes or escape rooms! I'm using the RF433Any library from https://github.com/sebmillet/RF433any More details about all of the projects featured on this channel can be found at Patreon: https://www.patreon.com/c/playfultech And you can join the discussion on the Discord: https://discord.gg/jhSJfF7D Timings 00:00:00 - 00:00:57 Introduction and Demonstration 00:00:58 - 00:02:59 Why clone RF signals? 00:03:00 - 00:05:25 Capturing RF codes 00:05:26 00:07:05 Filtering noise 00:07:06 - 00:10:22 Retransmitting commands 00:10:23 - 00:12:46 Wrapup

Comments

Jeff Keys

Happy New Year Alastair !

Annalise Shippee

I am using a simple RC car in my escape room that is hidden in the heating duct. They do not encounter the RC car until 45 minutes in. It is timing out before they get to it. I would like to maybe have another remote that I can send a signal so it does not go into sleep mode before they get there. Do you think this will work or do you have any other ideas on how to keep it awake?