Home Creators Posts Import Register Favorites Logout

Content

Designing and building new projects is fun, but maintaining and fixing existing props is a necessary task too!

In this video, I'll show how I was recently asked to repair an off-the-shelf escape room prop. The initial cause of failure was fairly obvious - a capacitor on the power board had blown - but after replacing that it still didn't function correctly, so I had to continue to investigate other problems, leading me to trace a pin map of all the inputs and outputs, monitor the serial output from the controller, download the code (and saved settings) from the original controller chip and restore them onto a new Arduino Mini, and ultimately rewrite the entire firmware.

One thing about diagnosing and making repairs is that it's very hard to specify an exact set of steps to follow - it will differ depending on the fault. But hopefully some of the processes and techniques I describe here will be useful to you if you ever need to fix your own props in the future.

One thing that I think many people might not realise is that, if your prop is powered by an ATMega chip (as found on an Arduino, and many off-the-shelf controllers including the one featured in this video), you can copy the code from that chip and restore it onto an Arduino replacement using ICSP. If you'd like more details on how to do that, please check out the resources accompanying this project (or ask in the Patreons channel of the discord server!)

Hope you're all well,

Alastair

Files

Fixing a Broken Electronic Escape Room Puzzle (Reverse Engineering + Arduino Rebuild)

In this video, I take a faulty "Connect the Wires" escape room puzzle prop and step through the process I followed to diagnose and repair it — from hardware investigation, replacing components, taking a backup up and then restoring code from the Arduino controller, and ultimately rewriting the firmware. Timings 00:00:00 - 00:00:55 Introduction 00:00:56 - 00:01:48 Overview Visual Inspection 00:01:49 - 00:02:21 A.I. Good! Identifying a Component 00:02:22 - 00:05:38 Replacing the Power Module 00:05:39 - 00:06:06 Detailed Visual Inspection 00:06:07 - 00:07:19 Initial Powerup Test 00:07:20 - 00:09:22 Serial Monitoring with FT232 Interface 00:09:23 - 00:10:23 Backing Up Arduino Code 00:10:24 - 00:11:14 A.I. Bad! ICSP Wiring 00:11:15 - 00:11:46 AVRdude Flash Download 00:11:47 - 00:12:06 AVRdude EEPROM Download 00:12:07 - 00:12:36 Uploading a Diagnostic Sketch 00:12:37 - 00:14:12 Determining and Documenting a Pin Map 00:14:13 - 00:16:19 Checking Raw Inputs 00:16:20 - 00:16:36 Replacing the Arduino Pro Mini 00:16:37 - 00:17:26 Repaired! (or Replaced?) 00:17:27 - 00:19:01 Wrapup This is real-world debugging walkthrough of a specific device, but the techniques and tools are applicable to working with Arduino-based props, escape room hardware, or embedded troubleshooting in general. More details about all of the projects featured on this channel can be found at Patreon: https://www.patreon.com/c/playfultech And you can join the discussion on the Discord: https://discord.gg/X46J7mab

Comments

Kevin Akat

Hey Alastair, do you have the Discord link? Wanted to ask a quesiton about this: https://www.instructables.com/Automated-Chessboard/ You should do a project on it! We have a haunted room and want to make it look like a ghost is playing it! Curious if sirvos/motors or what method you'd use to make the pieces move. Sorry for the irrelevant post, not sure where else to post. Thanks!