Home Creators Posts Import Register Favorites Logout

Downloads

Content

For today's tutorial, I wanted to decribe how you can use an Arduino to make a more interesting clue delivery system - if you're currently using microphones that enable gamesmasters to deliver clues as "The Voice of God" - broadcast over speakers in the room, then you can simply take a line out signal from that system and plug it into this circuit to create a light that reacts to the volume of the audio input. This is a simple and effective way to personify the  hint giver as a sentient object in the room, such as the "robot-eye"  light fitting I use in this video. But, you could just as easily use a "haunted table lamp", a "security AI system", or amend the Arduino code to control any other device in sync with the audio instead.

Part of my Tech Advent Calender for 2019! 

Files

Sound-Reactive Light-up Robot Eye for Escape Room Clue Delivery

In this video, I'll explain how to use an Arduino to create a light that glows in response to the volume of an audio signal fed via a 3.5mm line input. If you connect this to an escape room audio system as used to broadcast "Voice of God" hints spoken by the gamesmaster, you can personify the hint giver as a sentient object in the room, such as the "robot-eye" light fitting I use in this video! Part of my Tech Advent Calender for 2019! For my escape room tech projects, see https://www.patreon.com/playfultech

Comments

Rares

and the code ?

cshark

another request for the code :)

Bob Jones

This is great. Where can I get the code for this?

Hal Woods

This would be a cool quite place puzzle if manipulated. I think where everyone had to be silent for a certain amount of time for something to open

David Bodsworth

Hi Alastair, can I pick your brains quickly about this one? I'm using a modified version of this to make a puzzle where people have to make lots of noise. As they make more noise, a series of LEDs light up, and a relay triggers once they're loud enough. My code was working fine, with some debug serial prints, but when I comment out the debug define (or just the second serial print section), the LEDs don't light up. If you check the code below, you can see I added in a small delay after the serial print which seems to make it work again. Could it be that the code is just running too fast to light the LEDs. Is this normal? Or is there a better solution? https://github.com/davide1a/the-kraken.git Cheers