Home Creators Posts Import Register Favorites Logout

Content

Hello lovely Patreons!

You can access the wiring diagram and Arduino code used in the "Automated Ouija board" project from https://drive.google.com/drive/folders/1xPehM5aeOyluASP93HLXW7g9S_40lhUk?usp=sharing 

If, like me, you're using an Arduino Nano or UNO which only has one hardware serial connection, you'll also need to download the AltSoftSerial library to emulate the secondary, software serial interface. You can grab this from https://github.com/PaulStoffregen/AltSoftSerial 

If you have any problems with the hardware or software for this project, do let me know - there is a little bit of configuration required, so let me know if you get tripped up at all!

The most important thing to be aware of is that the GRBL control software running on the CNC shield (which is probably already pre-installed, but if not you can install it easily using the Arduino IDE) needs to be configured to run at the same baud rate as the AltSoftSerial interface in the CNCController.ino code. I use 9600 for both, and that works just fine in my setup.

If you choose to build your own frame, you probably will need to configure the number of steps/mm to match the resolution of the stepper motors you get. You can do this by issuing a configuration command via the Arduino Serial Monitor, as follows:

$100=80 (x, step/mm)$101=80 (y, step/mm)

You'd change the "80" value here to match your stepper motors, so that when you tell the stepper motor to move X1 Y1, say, it moves exactly 1mm right and 1mm up. Again, this is something that's made a bit easier if you buy one of the ready-made kits, since that's probably already been done for you.

Enjoy!

Comments

No comments found for this post.