Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Some GoKart Stub Axles arrived for my BatBaord (see the post down the wall). They are pretty beefy so they should hold the wheels fine as long as I can hold the stub axles fine. Quite a lot of thinking to do about how to actually actuate them with the wheels facing inward since the rack would cross through the wheels when they turn if I used the levers on them in the conventional way. I'm considering just pushing the pulling the wheel hub from the inside of the wheels down the centre of the board.

Part 3 of the LEGO skateboard is half made, it has working lights!. However I still need to get out and drive it again - the weather is raining at the moment, so I'm hoping the video will be out in early August. I was intending to have drone footage also but we'll see how the coordination goes with the drone owner.

Files

Previews only

Comments

designasaw - Alex Heap

I'm sensing a small scale lego technic model is required. In fact what about building a small 3D printed model and then scaling up for the final project

XRobots

Yes I probably should, although the forces involved get much much bigger as you scale up...

XRobots

yes stub axles are angled so the vehicle rises when you steer and settles with the wheels straight at the low point. It's easy when the wheels stick out from the chassis rather than inward from the outsides.