Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

So I got the wheels on and most of the steering assembly done - there's a round pulley inside which pushes and pulls the front wheels, that pulley is in-turn driven by a chain drive on a wiper motor at the back which I'm yet to add.

I want to make it run before I publish part 1 and that'll give me two parts for consecutive weeks. For part 3 onward, the plan is:

-Cosmetic panels and other parts including the 'afterburner' on the back.

-Full remote control with FPV.

-Laser guided mode so I can operate it with one hand, possibly collision avoidance.

-Bat projectors and other lighting.

-Speech synth to tell me which mode it's in.

-Bluetooth speaker, FM radio, cup holder etc.

Files

Previews only

Comments

Anonymous

that is a tricky design...i guess Akerman is built into the pulley/rod thing? It won't matter too much as it does not look like it does real tight corners but those fat tires will fight you if you dont have some angular difference

Anonymous

It is possible to steer it with your foot as well if that pulley was projected through to the board surface, then just turning your foot on it would steer...like a lazy Susan table thing. It would need auto-center though.

XRobots

I can change the angles by moving the rods closer together on the pulley, but we'll see how it goes for now.

XRobots

It's going to be motorised, so I'll have a hand controller - we'll see how that goes as well ;-)