openDog! (Patreon)
Content
It's in the very early stages of planning - this time I'm going to plan most of the structure and work out the kinematic model before I build it. That means writing a kinematic engine made from maths which knows what all the angles and actuator lengths are so that I can request the robot to position any of its leg end-points anywhere in XYZ space and it'll be able to move all the joints accordingly. It's basically a lot of trigonometry running in real time.
So far I've made the remote which has two 3-axis joysticks for control of the 6-axis, so it can transition laterally in three dimensions and also do pan/tilt/yaw moving its legs like a motion platform. That means I can turn my kinematic model into code and check the actuators and angles are correct by manipulating and measuring the CAD. The same engine will of course be used for path planning to make the different walk gaits.
It'll mainly be made from Aluminium extrusion and milled Aluminium plates. I should be taking delivery of a CNC machine in the first week of May. There will of course still be a place for 3D printing in the project.
Actuators are likely to be brushless motors and ball screws like the ExoSuit because they are agile and not too costly. I'm leaning toward ODrive Robotics motor drivers with encoders, and Teensy 3.6 as the main processor - at least for motion control and doing all the kinematics.
---
This is of course not the approach I took with RobotX - that is pretty much just adding some numbers on here and there to try to balance. That project probably has a couple more episodes in it and then I'm also going to open source it.
Files
Previews only