Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Going on from my picture of the CAD a few days ago, here's a prototype of the real thing for part 2 of the series.

The parts are 3D printed for now, it'll be a while before I cut metal parts and there's a fair bit of thinking to do before then.

Part 2 of openDog comes up later this week for Patrons only!

Files

Previews only

Comments

Anonymous

If there are "bearings" in the plastic rotation points (to reduce wear) this might be strong enough. Anyway good enough to get started.

XRobots

The rod ends have brash bushing, but in the video I discuss other options. Eventually a lot of it will be machined aluminium

Anonymous

Sounds good. even aluminium needs bushings. Aluminium is not wear resistant at all. I also learned not to use threads in aluminium and expect them to last. All because aluminium is not wear resistant.

Scott Cress

Would directly gearing the motor to the shaft instead of using a belt be more reliable? Or is the flexibility needed?

XRobots

Belts tend to be quieter and more forgiving in terms of alignment, it's the same setup as the ExoSuit, so I know it'll take enough load without skipping.

Anonymous

We were talking aluminium->Steel; but yes engineers use bushings for moving steel parts against steel as well, and I'm an engineer. There are all kind of bushings, brass, bronze, PE,.... They all have their pro's and cons. There is however one advantage to all and that is... wear will wear the bushing which is cheaper and easier to replace. That is off course next to the reduced friction advantage