Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

So here's a preview of what's coming in Part 3. It's mostly sorting it all out so it can be physically made - starting in Part 4, albeit in small stages as I find my way with it.

Just need to fine tune a few small things, but I'm pretty confident.

Files

Previews only

Comments

XRobots

That's fine with me. It's interesting although I'd like to see the whole robot move.

Darius Zaerin

me too. i don't know how much he's working on it but it looks like he's pretty far along, so its just a matter of time :)

bruceneely

looks lie an interesting project, but I don't see anywhere where he gives license to the use of any of his work, you can follow the project and he's giving out files but how can they be used?

Darius Zaerin

hmmm, i'm not too sure. on the youtube video he says "The Actuator is fully open source and the Mechanical design, Electronics and Software has been published online" so i guess he knows the difference, but i don't know under what license. you'll have to ask him. :-)

XRobots

If it's on Git then you can specify the license, but are the files just on Hackaday.io ?

XRobots

Looks good - it doesn't have the non-commercial tab at least, so it's probably proper open source. That said copyright licenses are generally only good for aesthetic things, so it probably wants a GPL2/3 on it too

bruceneely

The version on thingiverse looks to my unskilled eye to be the same as what is on his hackaday webpage and had no restrictions on the license, So I would say he intends it for open use.

bruceneely

I've been wondering what yo were planning to keep your motors cool, under constant load of walking or even running they are going to be generating quite a bit of heat I think.

XRobots

I've been thinking about this, and if I use 3D printed motor mounts if they would melt. However the ExoSuit motors didn't even get warm. In openDog #3 I do a short strength test - trying to hold the leg back by applying force from the top and extending it - I can't physically hold it back, and that's only at 30A and 24V, which is about a quarter of the potential power. So I suspect that they are fairly over powered and I won't have to drive them that hard.