Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

I'm planning to start openDog #4 next week which will involve cutting aluminium with the CNC machine.

I have metal cutting bits that were provided with the machine, and the rest is down to keeping the part cool and removing chips from the piece and cutter.

I got hold of a 'silent' compressor - it's about 65dB which is bearable. The plan is to set up a hose to blow air at the cutter to blow the chips away which removes heat. 

There's also a thing called a 'Fogbuster' which applies coolant in the air stream, but stops it causing fog/mist in the air. I don't have one of those yet, so I'm just going to try brushing the coolant on as I go, which is apparently just about ok.

I have a couple of other videos coming in the week between openDog #3 and #4 though - more updates on those soon.

Files

Previews only

Comments

Artype's Halo

Hey James, I actually milled my first aluminium on my CNC this week! I found that pooling some oil around the cutter (I used about half an egg cup of medium viscosity oil) kept the piece quite cool and every couple of minutes I used a brush separate as much of the swarf from the oil as I could, replenishing the oil pool as I went. The results where excellent! I look forward to seeing how you get on!

Anonymous

Looks like things are getting pretty serious. I have a Shapeoko 3 XXL, but I haven't had much luck cutting metal, not knowing anything about the topic is part of the problem of course... Good luck.