Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Here's a short (not billed to Patrons) preview video of the CNC machine cutting aluminium, for Patrons only. This is just a 1 minute preview video which is part of openDog #4 - the whole video should be up for Patrons on Weds/Thurs as usual once I'm done with some 3D printing and assembly.

In this video I'm cutting as follows:

22,000 rpm on the spindle 

6mm carbide end mill, I have some 4mm ones on the way.

0.1mm depth of cut (65 passes to get right through 6mm plate). Haven't tried any deeper.  I also found it was much happier ramping down to the next level over 50mm or so rather than plunging, even though it's only 0.1mm - it makes a screeching sound otherwise. 

70mm per second feed rate - that's the speed of travel. CNC Router Parts said to cut at 200-220 inches per minute which is about 85-90mm/ second. 

I'm brushing on coolant/lubrication every so often, once it dries out you can hear a cutting sound like it's cutting wood, but with the coolant on it's silent - most of the sound you can hear is the motor cooling fan which is like a high speed turbine in the top of the motor.

I did try blasting the part with compressed air to remove the chips (with the blue hose attachment) but it just blows the coolant away, so I'm clearing any debris manually so often with the brush and with a hand air tool. There's a thing called a 'Fog Buster' which I think I need.

There are various thoughts about how to cut parts like that, some people think 'slotting' in a straight line like that is bad, so some people will shout at the screen - particularly if they watch 'NYC CNC' and have never actually tried it, but this is addressed in the video, as well as the other points.

That part took about 40 mins as it was without doing 'adaptive clearing' to cut wider channels around the part. I had to cut 8 parts, which including sorting out the tool paths and working out what I'm doing, stopping for lunch etc, has taken about two days - and I stood there and watched every one in case it went wrong (for now).

Happy the lighting works well in my box!

Files

Previews only

**CNC video for Patrons Only!**

Preview from openDog #4 for Patrons only.

Comments

Anonymous

How many flutes on your end mill? Every material has a small range of engagement depths which will produce good chips. Too shallow and the material breaks off the forming chip (that's the fine powder you are getting) or gets melted and tries to compress under the tool leading edge. Too deep and and all kinds of failure modes occur (stall, breaking, chip melting, chip jamming, etc). You need to find out, for your material, what the proper loading is *per flute*. Then you can calculate the RPM you need for a given feedrate. Given lack of automated coolant you should be aiming for the lowest feedrate which your spindle and mill will allow. That allows more time for the flutes and material to conduct heat away.

XRobots

This one is four flutes, but I have some with w on the way - I think that may be where my issues is.

Anonymous

Oh, and cutting depth is mostly a function of the side loads your system can handle. The mill can take only so much...the closer you get to its max the more perfect your chip size needs to be. Also your machine can only push so hard before it either stalls or deforms (no longer holding the mill at the same angle to the work piece). The mill end will have a rating for safe side loads, and the material you're cutting will have specific properties relating flute engagement to loading force (it's a combination of the forces involved in forming the chip)

XRobots

I need to do some more testing - the material is 'some aluminium' from eBay