Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

While awaiting openDog parts and other things so I can proceed with the project, I decided it would be good to do some tests with a less rigid leg - one with a stretchy tendon.

So this is a test leg for 'openJumpy', which will be the next video. It has one brushless motor motor for now that pulls the leg and makes it longer. I'm using the whole motor body as the pulley, and ODrive plus the encoder on the motor to position it. There's also a feedback pot on the actual leg joint so I can measure the difference between motor position and actual leg position, and calculate the force being applied to the tendon/leg, or make it apply more/less force etc.

It should also be possible to put it into 'compliant' mode where the motor would track the leg/pot position so you could push it up and down and have it hold the position, and of course absorb a load as it impacts the ground.

It's on a pivot so it doesn't fall over - if I ever make a robot out of it it'll have at least three legs ;-)

I've not actually powered it up yet, or fitted the tendon, but all being well the video should be up for Patrons next week.

Files

Previews only

Comments

bruceneely

Looks very interesting. Open Jumpy seems to be an interesting concept, is a motor going to respond fast enough on a lead/ball screw to actually jump?

Anonymous

I wonder, I saw your video about making a custom servomotor with an encoder and PID software. You said that it is less good than an ODrive, but it is more affordable. What problems do you encounter using a custom servomotor in comparison to an ODrive? It did not become clear to me from the video and I cannot seem to find it easily online.

XRobots

There's no ball screw in this - just a pulley attached to the motor body. However I have (accidentally) had openDog jump off the ground in its current form.

XRobots

ODrive allows brushless motors to be used very accurately - there's much more power density in bruhsless motors than the DC motors used in both the servo & linear actuator examples.

bruceneely

sounds fun, this should be interesting to watch then. Maybe, would be interesting to see OpenDog jump

XRobots

That's the plan - should be able to put it into compliant mode and absorb the load.