Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

This is my first welding project, which seems to have turned out ok. All TIG welded, so not bad for my first go. 

The rollers are a bit small for rolling box - it kinks up and then I can't roll it anymore, but plate/bar rolls really well. I can get a minimum radius of about 120mm.

 Full video comes up for Patrons on Tuesday and goes out publicly on Tuesday 19th. 

Files

Previews only

Comments

Scott Cress

Nicely done, for a first "tool making" project.

Scott Cress

I think Colin, or someone, made something similar a while ago. They suggested using round tube stock not square for bending projects like this.

XRobots

Making a tube notcher is on the list, pretty sure the box in this project is more than strong enough to overwhelm whatever I'm going to roll.

Anonymous

thats cool, I wouldnt put anything too strong through there might warp those rods unless they are hardened

XRobots

Yes they are only 20mm dia, but whatever goes in there of course makes the rollers roll over and over so the force would get applied to all sides. There is come discussion in the video about upgrading them to 40mm.

Anonymous

yeah you will be fine as long as it rolls through at steady pace, too slow though with thick stock could bend em

Scott Cress

100% agree it looks good and strong. It's that box tubing tends to fold and kink. Round tube doesn't.

Scott Cress

I think I see where the miscommunication was. I was talking about the materials to be bent in the roller not the materials used to make the roller.

XRobots

I see - I've not tried rolling tube in. There is a special 'pipe bender' that also stop tube flattening.

Scott Cress

Yes! It is called the Hossfeld bender or a Universal Bender as the generic.