Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Another preview of next week's video for Patrons. Taking a one-week break from robotics to try something else a bit simpler. 

It is around 1 metre long and made from cardboard tubes (the ends are 3D printed, but it's the bridging part I wanted to test the strength of). I only used PVA/white glue to hold it together, so no fiberglass resin or other materials in the main board part - just cardboard!

I'm open to predictions for how far it get on it...

Files

Previews only

Comments

Adarsha

Put one thin sheet of cardboard (like a side of Amazon box) and that should make it spread the load across wider area and across tubes.. With that seeing your physique I don't see any it can't hold you comfortably

John N Nelson

Don't get it wet. I suspect the stresses at the cardboard/3d printing joints will be a failure point. It's good to take a break from hard work for a while. Thanks for bringing us along.

George Hartt

Take all the break that you need, please don’t burn out

Anonymous

Astonishing over and over. You must have thousands of ideas floating around in your head. I love the content you produce James and can only imagine how much work must be going on behind the scenes for each project and video. I also pity your 3D printers as they probably never stand still. But most importantly: Please make sure not to overpace and take *real* breaks whenever you feel like it to preserver your own sanity and quality of life. Best from Germany!

XRobots

Thanks! well I'm going on holiday in March, but there's probably a related project for some of that too!

Anonymous

For a terrible moment I thought they were rocket motors!