Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

My motors arrived, they are Turnigy Multistar 9225 90KV motors. Part 2 of openDog V2 will be about building one test leg with two joints so I've started to look in more detail at the design (video part 1 with the overview is further down my Patreon wall for Patrons).

I have a very good feeling about this so far - I've powered up one motor with a 5:1 belt reduction, on just 20A max at 24V (we can get four times more power if needed). Due to the large diameter and large amount of pole pairs in the motor it's incredibly strong - if I try to back-drive the large output pulley, then the ODrive increases holding current and pulls it back which I can't stop with my hand.

I'm using the AMS AS5047P magnetic encoder which does ABI (quadrature) and also absolute position which will be extremely useful.

Belts are 9mm wide 5mm pitch HTD belts. I trial-and-errored the pulleys to get the best for for 3D printing. 14 teeth and 70 teeth to give us 5:1.

The leg is looking quite chunky so far, my intention is to make it mostly 3D printed if possible. Once I can test the load we can apply to the top of one leg I'll go back and refine the design before building the whole thing.

Files

Previews only

Comments

Mac Pierce

May be interesting to try out the Topology Optimization in Fusion when you reduce the part size. Thomas Sanladerer did a great video on it - https://youtu.be/3smr5CEdksc

XRobots

I've considered it, I think there will be lots of forces in all directions including torsion. The prints aren't solid anyway and I've a feeling the motor power will be more than enough to handle moving any bits of plastic ;-)

Adam Purdie

Looking forward to the videos :D

Anonymous

This might be slightly off topic but I often struggle with printed part durability under stress. Do you do anything during design or printing to try and optimize part strength?

XRobots

More perimeters and just making them really chunky! I use the MOARstruder quite often which has a 1.2mm nozzle and makes the parts really strong!

Shadow

This looks promising! Can't wait to see it in action!

Scott Cress

That yellow and blue has a strong Ikea feel to it. 😄

Scott Cress

Question though, why do your legs start off bent instead of straight?

XRobots

Mostly so compliance can work - if the joints are locked straight then back-driving the joints when the robot moves fast won't work well.

Anonymous

Hey James, have you seen this video? https://youtu.be/utDagouxM5U It's a 1:20 zero-backlash reduction that seems very easily backdriveable. Just in case you need a higher reduction at some point.

XRobots

Yes I subscribe to that channel and it's featured in the first openDog V2 video. I don't need that much reduction though, and I may need more rotational freedom.