Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

Here's a preview picture of my test leg for openDog V2. The full video comes up for Patrons early next week. 

It's looking pretty good, this leg was built primarily to test the feasibility of my single-stage 5:1 belt reduction - and to see how much load the leg will take so I can see if it's enough to hold up the remaining mass when two legs are off the ground. 

The knee takes most of the load as expected, and of course this is more obvious the more bent the leg gets due to the leverage angle.

I need to reduce the mass of this leg a lot, and there is some information in the video about that, but I still have a lot more testing to do for 3D printed parts in terms of rigidity and structure vs mass. I'll be incorporating carbon fibre tubes in the design, but I've also considered an extra gearing stage in the knee only, a bit like my previous brushless motor driven test dogs It's looking pretty hopeful all together though.

In other new, balancing Streendbeest looks like it'll 'probably work' ;-)

Files

Previews only

Comments

bruceneely

looks interesting, the Streendbeest project also looks interesting though.

Anonymous

Nice! I like those double belt tensioners :-)

XRobots

Well the plastic is bending in this version, so in the future there will be a brace on between the end of the motor pulley and the large output pulley - so that large yellow piece will be two parallel plates. Then I may not need to idlers at all, but we'll see.

Anonymous

You could consider using carbon tubes instead of 3D printing all for the legs. Carbon tubes is used fx. for kites and they come pretty cheap also. Knee joint, foot and shoulder could be 3D printed off cause.

Adam Purdie

I'm not sure if i mentioned this but i got some great weight reduction on one of my bigger robots by having a spring cross the rotation. Find "spring pre-loading" here : https://medium.com/@mr_koz/yorick-the-heavy-robot-f8502217b0d9#d2ba for pics - it means that the effective spring power on the joint changes as the angle of the joint changes, I lack the training to explain it or give it a good name but it's quite simple when you make it :) I effectively reduced the weight on each leg by 40% on my big robot, the cost was introducing that weight on the lift side of the motion... still a win!

Adam Purdie

Now that i think about it, the angles of the leg would probably be better served by a double torsion spring on each joint :) my complex displacement spring arrangement is because i have different forces on the spider legs :)

XRobots

The lower leg will be carbon fibre tube, it's just difficult to to it all and get reasonable mounts to tension the belts, mount the motor etc in there.