Home Creators Posts Import Register Favorites Logout
haven't archived this post yet. have a subscription? use the importer!

Content

A short update on progress with this one. I have the four hip assemblies together. The motors have bearings in the end of their pulleys which are braced with a piece of stainless steel rod mounted in the 3D printed plate opposite. This plate also holds a bearing to double-brace the 2020 output shaft which turns the 'shoulder' of the leg. 

The new parallel structure seems pretty solid and the belts are pretty tight, there's no bending of the plastic parts this time due to the double bracing on both large and small pulleys.

The hip (and knee) joint axis are now plastic stubs with thin wall bearings mounted on them, so I've lost all the steel studding, nuts etc and skate bearings, so this should bring a weight saving to the whole thing. I'm hoping to shave at least 500g (about 1.1lb) from each leg since the test leg I built and I aim to get the whole machine under 15Kg (that would with no batteries and electronics though).

3D printing is probably the best way to build this for now, but there's no reason I can't add more carbon fibre plates to it in the future and minimise the chunky plastic even further. Most of the prints are 4 perimeters and 20% infill for now, some may be less dense.

Files

Previews only

Comments

Anonymous

Do you think you could get away with sharing the hip motors on each side (ie, 2 not 4)? Should save a kilo or two, although I'm not sure how it would affect steering.

XRobots

You'd have issues turning because you wouldn't be able to do any yaw moves. I've thought so may times about trying to reduce motor count in robots, but it's really hard when you need multiple joints moving at once. I tried this once, but that was as far as I got: https://youtu.be/HQa1-jP9NBo?t=880

Asger Vestbjerg

Great simplified design Great update👍😀

Anonymous

What gage of wire are you using for the motor?

XRobots

The motors come with long wires attached - for big drones I assume. So there's more than enough tog get to the ODrive. Then I have some fatter wires to get power to each ODrive since each one control two motors.

Anonymous

I have always been wondering if creating holes and cutouts with 3D printing is really an advantage for the weight / strenght ratio over just have the object solid and choosing f.e. graduaded infill in the slicer. The extra walls add up to the weight and i dont know whats stronger in the end. Anyone did tests on that? For laser cutting etc. i also do holes and cutouts but printing i usually dont bother..

XRobots

That is a good question - maybe the extra walls help with the part rigidity with no extra weight?