Home Creators Posts Import Register Favorites Logout

Content

DALI stands for Digital Addressable Lighting Interface, and it's a very rugged low speed network system for things like office/stadium lights and street lighting.

Some of its most notable features are that it can be run in amongst mains wiring in normal wires with no specific polarity, and low current devices like sensors can be powered directly from the 2-wire network.

For a network to actually work, one of the devices on it has to provide power, and communication is achieved by short circuiting that power in pulses.

https://youtu.be/joyf5FezmEc

Files

DALI lighting network PSU with unusual and specialist circuitry

This dinky little 1W power supply is intended to power a DALI (Digital Addressable Lighting Interface) network and some of the devices on it. The DALI network system is not a high speed lighting control network as it sacrifices speed for ruggedness and simplicity. It uses two wires to communicate, and those wires can be standard cable thrown into the same containment as mains wiring. As such it can't really be classed as proper SELV (Separated Extra Low Voltage). The wires have no specific polarity and can be the same colour. Devices like controllers and sensors can be powered from the network if they use very low current, and they communicate by literally shorting the network out in pulses. Some examples of DALI control could be street lighting where the dusk or movement sensor is on a very small internal network, and for office lighting where the lights can be divided into zones with managed control based on time of day and movement sensors. If you enjoy my videos then the easiest way to support the channel is to subscribe for more good video content. But if you would like to contribute a dollar or two for coffee, cookies and gadgets to take apart, you can do so by supporting me on Patreon. I release videos without adverts for critique and feedback on Patreon as soon as they have been made. I also do Patreon live streams, which are much more relaxed and chatty than the busy public ones. https://www.patreon.com/bigclive Alternatively, for a single coffee contribution you can use PayPal:- https://www.paypal.com/paypalme/bigclive #ElectronicsCreators

Comments

Dave Frederick AKA @amorphuc

Wild! Thanks Big Clive! I sure don't know you make sense of this at all but it seems pretty cool.

Bastian

The moment you get told DALI is a type of interface. hah. I have been thinking that it was some sort of brandname until today...

Mike Page

Interesting, thanks Clive.

DC Allan

Interesting device, your guess is as good as mine with regards to the circuitry. .

richard ockman

Very nice, do you have any other Dali modules.

Zeedijk Mike

Maybe I'm a little nitpicking (is that a English word?) - But the upper of two 0V you added to the diagram (at the output) is more like a "virtual ground" as it is connected to the 0V rail via the diode, FET and the 7.5 Ohm resistor. Must admit I'm still not sure how the system works. Who or what creates the short circuit data pulses and what receives the pulses?

Big Clive

It's built into quite a few of the street lighting LED drivers I have here.

Big Clive

I did slightly regret marking the power supply output as being 0V. I should have left it as just the negative identifier. The PIR sensor I showed would power itself from the network and also short out the network in brief pulses to send data to whatever was programmed to recognise it.

Gordo

Hi Clive, very interesting and informative as always. I knew DALI was some sort of 1-wire interface but I now know how it works. I like your idea of reverse polarity protection, but after dropping 13V across the zener diode, I don't see how enough current could flow through the 820k resistor to switch the transistor (datasheet gives Hfe between 100 and 400). It almost looks like some sort of feedback for the current regulator. The low-side switching has my brain confuddled

George Cohn

Sounds something like the old Gamewell Fire pull boxes that used a clockwork to pulse out the box number.

Brett Kuehner

I started watching this video but today it says it is unavailable (private). Since I'm a Patreon member, I'm hoping I can get access again. I talk to DALI devices for work, so I'm interested in seeing the details of this one.

Big Clive

Sorry, I changed it to scheduled 6pm UK-time release today and when I do that it automatically resets it to "private". It will reappear shortly.

Big Clive

If you have any questions regarding Dali networking just let me know here.