Home Creators Posts Import Register Favorites Logout

Content

I had high hopes for this, but the PCB is not compatible with the mountings on the battery module. To actually use this you would need to get busy with glue and foam packers.

The classic small module as found in the standard Fakita batteries would probably be better suited to this case, as a low current energy storage block.

https://youtu.be/uX-b7MTJ5Bw

Files

30 cell Fakita battery kit with issues

I kinda like the Fakita battery system (Fake Makita) as it is a useful battery pack with built in protection against over-charge, over-discharge and overcurrent. This kit comes without cells and is supposed to make a monster 30 cell battery with five series sets of six-paralleled cells, giving the potential for a 14.4Ah pack if using 2.4Ah cells. (The Ah capacity is at the rated voltage and not all the combined cells, so it's just six times 2.4Ah.) Unfortunately, the control PCB that was supplied is incompatible with the mountings on the battery frame. It might be viable to bodge it in somehow, but it's not recommended. Even with one of the smaller modules rated for lower load current, you would need to glue the PCB into place and have fly wires onto the battery block. The control PCB is interesting as it uses the same control chip as the smaller modules, but has extra buffering to drive a large parallel array of load control MOSFETs. The gratuitous application of very stubborn silicone made it frustratingly difficult to do a proper full reverse engineering of this pack. I did find some things that made me prefer the smaller PCBs if the high current switching isn't needed. Depending on what you wanted to do with it, the kit could still be viable for the cell assembly, so if you want to explore one then here's an affiliate link to the AliExpress listing:- https://s.click.aliexpress.com/e/_c3b7JvTP Interestingly, the control PCB shown in the listing is similar, but different to the one I received. If you enjoy my videos, supporting the channel on Patreon helps keep it independent of YouTube's quirks, avoids intrusive mid-video adverts, gives early access, bonus footage and regular quiet Patreon live streams. https://www.patreon.com/bigclive Alternatively, for a single coffee contribution you can use PayPal:- https://www.paypal.com/paypalme/bigclive #ElectronicsCreators

Comments

Keith Who

Fake in more than one way. KW.

Kevin Horne

I wish you'd done this review a couple of months ago! I bought one of these kits to put to work a bunch of matched 18650s which I had lying around. I discovered exactly the same problem that you did. I got around it eventually by judicious application of hot melt glue in place of the spurious mounting pillars. Not ideal, but it does work!

Mike Hughes

I just googled"what can disolve silicone goop off circuit board" and there are lots of options. but acetone is mentioned along with propriety branded stuff.

Dave Frederick AKA @amorphuc

Interesting. Thanks Big Clive. I would wonder if the comment section would have others being frustrated by the assembly of the mismatched parts?

joe wrench

so much of this stuff is just crap.

Big Clive

You have to look at it from the component perspective and see the potential of cherry picking the good bits.