Home Creators Posts Import Register Favorites Logout

Content

A closer look at the incredibly simple design of a thermally activated manual-reset overcurrent protection device.

The purpose of this device is to break the current to a device if it exceeds its rating. It is not suited to breaking high fault currents like a mains voltage short circuit.

A good example of this is to protect a motor, where there is a risk of the motor stalling and passing high current.

https://youtu.be/ql9sZ0OpCJg

Files

Thermal overcurrent trips are amazingly simple inside

I was really surprised when I opened this up. I thought it was going to be much more complex. These devices are purely intended to break current limited faults like overloads, and not really ideal for breaking high short-circuit currents. One example of their use is in a motor circuit where the current increases dramatically when the motor stalls, and it's important to switch it off quickly before the motor suffers thermal damage. They can also find use on the secondary side of transformers, where the fault current is inherently limited to a manageable level. Here's a link to "Let's be techs" HVAC maintenance channel:- https://www.youtube.com/@UChH1LTsB4IzJ_qiTh23_pJQ If you want one of these for a non-critical application or just to open, then here's a link to the item on AliExpress (not a sponsor). This is an affiliate link, but that will not affect the price you pay. https://s.click.aliexpress.com/e/_c3f7Pbdj The cost is low - maybe too low, so treat these as a novelty item, and if you have a safety critical situation then buy one from a trusted source. Even from a prominent supplier they are not very expensive. If you enjoy my videos, supporting the channel on Patreon helps keep it independent of YouTube's quirks, avoids intrusive mid-video adverts, gives early access, bonus footage and regular quiet Patreon live streams. https://www.patreon.com/bigclive Alternatively, for a single coffee contribution you can use PayPal:- https://www.paypal.com/paypalme/bigclive #ElectronicsCreators

Comments

Mike Hughes

Sometimes the simplest solution is the best for the desired outcome. That case looks as though it was 3d printed, Is that something you can check? anothe question I have is about Bi-metallic strips, are they riveted together or soldered/fused, because I've often wondered about how they work (I know about the difference in the co-efficience of thermal expansion of metals ) but don't actually know how these strips are made.

Big Clive

The case is moulded. These are a mass produced item. Apparently bimetallic materials are made by rolling them together with high pressure and heat.

Mike Hughes

Oh wow, I never knew that. thanks Clive, that is so interesting to know. That must be one hell of a pressure to fuse them together. Jeez that must be intense, but there again, most bimetallic strips are only a few mm wide, that one seems fairly wide though!

James Demers

Brass/steel bimetallic strips (the least expensive variety) are bonded by brazing with a silver/copper/zinc/tin alloy. I would think that a thin foil of the alloy is simply rolled between the metals under high pressure and at the appropriate temperature, or else one of the metals is silvered with the alloy prior to the rolling/heating step.