Home Creators Posts Import Register Favorites Logout

Content

Quite an impressively simple design for a bright panel-mounting voltage-meter with a very bold display.

At this point in time I am quite impressed with the audio and video quality of the Samsung A35 5G I recorded this video with.

https://youtu.be/wkGge61MUXI

Files

Ultra-optimised panel voltage meter (with schematic)

This panel mounting voltage display has only nine components including the display. It's a great example of cost optimising and space saving. The circuitry includes:- A capacitive dropper power supply with inrush limiting fusible resistor. A microcontroller. A low pin count tri-state multiplexed display. A voltage divider for monitoring the voltage. Very lean software to average the sensed voltage, convert it and then scan the display. It's a very clever design, optimised to fit into a classic 22mm panel mounting insert. The first versions of these had a standard display and a bezel. But the new ones have a custom display to give the biggest and clearest digits in the available space. Although fairly accurate as supplied, the displays do rely on close tolerance components. It is possible to tune the accuracy if you have the time and patience. If you want one of these to play with (or just marvel at its simplicity) then here's a link to the item on AliExpress (not a sponsor). This is an affiliate link, but that will not affect the price you pay. https://s.click.aliexpress.com/e/_c3CmWREL The cost of these is really low. About £1.50 shipped. If you enjoy my videos, you can treat me to coffee, cookies and gadgets by supporting the channel on Patreon. You also get early access to videos without adverts, bonus footage and regular quiet Patreon live streams. https://www.patreon.com/bigclive Alternatively, for a single coffee contribution you can use PayPal:- https://www.paypal.com/paypalme/bigclive #ElectronicsCreators

Comments

Stuart-AJC

Yes, the audio and video is great with the new camera

Mike Page

Thanks, Clive. 253 vs 249 smells a bit like RMS vs Abs-Average. You really want to use your best DMM before you decide to recalibrate. Most modern Flukes (even two pole testers) are RMS. Fluke had their own silicon fab at Everett making a custom RMS to DC chip. The last meter to use it was the 189. After that they shifted over to mainstream parts. The 189 is a great meter.

Dave Frederick AKA @amorphuc

Thanks Big Clive. Seems like a lot of work to get it be accurate but then I guess, It's worth it for an engineer to work with. My dad was a calibration engineer for Stewart Warner in Chicago years ago, he would probably have loved this.

Beads

Great 4K video quality and crisp audio. That Samsung looks bang on!

joe wrench

There is that selective resistor at work again. Hey Clive! Put that bad boy up for auction!!

Big Clive

I kinda use the resistor selector a lot. It's a shame they stopped making them.

Keith Who

Why is the zener on the anode of the rectifier diode and not on the cathode? Does the zener not represent a near short circuit on every half cycle of the AC input?

Big Clive

It shorts it out on one half of the sinewave and caps it at 5V on the other half when it is also charging the electrolytic capacitor via the diode. The way a capacitive dropper works, it needs both halves of the sinewave, but only half is being used here for the lowest component count.