1st Division Commander (Patreon)

Heeey, guys, what's up! Pineapple head is here!

Thanks for waiting, everyone. Our Marco figure is out and ready for our printers. I needed some extra time to finish him because I wanted to experiment with some new techniques and cuts on this model. Since Marco wears a lot of stuff and this figure has an extra head, I separated all the pieces to make it easier to print and paint.

And talking about the pieces, I just made a few more cuts for those who want to print him bigger.

• The base can now be printed as 3 pieces
• The wing can be printed as 2
• All the 3 tails can be printed as 2 pieces and they were renamed "Tail-A", "Tail-B" and "Tail-C". 

I changed the names to be able to use the numbers "1 and 2" for the parts.

In the "Simplified" folder you can find the "full version" of the pieces, such as BaseFull and WingFull.

To get the latests cuts, just download the model again from the same link.

The default size of the figure is:

Height: 20.6
Length: 23
Width: 15.7
Centimeters

The pre-supported version of Marco will be uploaded this week. Sabo's presupports were just dropped and Yamato's will be done tomorrow. Stay tuned!

I think that's it for now, folks. See you in the Next Release post. I hope you have a good week and that you enjoy the model. Stay safe. Happy printing~~