Magnetic Fidget Circuit Board 2.3 FILES (Patreon)

This Fidget was printed on a Bambu Labs X1C using an AMS and is ready to Fidget with directly off of the printer. When using Bambu Studio the included 3mf file will automatically pause the build after the areas for the magnets are printed. Simply insert 6 magnets into one model and reverse the magnet direction and insert 6 more magnets into the other side. Then resume your build and the printer will print directly over top of the magnets trapping them inside. I used a 0.4mm nozzle and printed at a 0.12m layer height. The fidgets move best when printed on the standard textured plate. The textured surface printed against the bed must be the sides that face each other for fidgeting, as the top face has a slight texture.

Each Side has a 2x3 magnet pattern, using the same size magnets as all of my other current fidget design. The magnets I use can be found here along with some of the filaments I used….

https://linktr.ee/mzmdigitaldesign

For the models shown in the photos I used the following filament…..

eSun black PLA+

eSun silk blue PLA

CC3D silk gold PLA

CC3D silk silver PLA

Eryone silk Yellow/Green PLA

Eryone silk Red/Blue/Green PLA

I would love to see your color combinations. Tag me on TikTok.

Let me know if you have any questions. Thank you!

Mike

30MAY2024 UPDATED FILE: I just updated the attached 3mf file. I slowed down the outer layer and top layer surface speeds to produce a much nicer surface finish.