Magnetic Fidget - Poker King - Updated 👑 ❤️ (Patreon)

In order to achieve the high gloss glass like finish I printed the top section face down against a WhamBam PEX built plate. (Link below)

For optimal fidgeting performance the bottom closure plate should be printed against a textured build plate.

Each side has (6) 8x3mm neodymium magnets pressed into the holes, I use an arbor press for easy assembly. Remember to reverse the magnet polarity between the two sides.

I highly recommend using the Attached m3f file, I slowed down the outer wall and top surface speeds a little bit, which results in a much nicer and much shinier surface finish.

The magnets I used were purchased from Amazon, using the link below….

https://linktr.ee/mzmdigitaldesign

Arbor presses can also be purchased on Amazon if you are planning on making more than a few of these.

These were printed on a stockBambu Labs X1C and P1S

Standard 0.4mm nozzle

Fine Resolution 0.12mm layer height

Infill: 60

As always please let me know if you have any questions! Thank you!

Mike

UPDATE: I do apologize, The original 3mf file for the Top Plate was inadvertently saved with a modifed Travel speed of 20 instead of 200 so you may have run into some issues with globbing and stringing while printing the top plate. I modified the settings and attached a new file. Please discard any files previously downloaded for this fidget and use these new updated files. Thank you!