Sugar Skull - Magnetic Fidget (Patreon)

This Print-In-Place Magnetic Fidget design is highly customizable and if you don’t want the sugar skull design on the back just remove the colors in your slicer or print this design with a single color printer.

If you print the attached 3mf file the build will pause at layer 30, at which point you can easily insert (6) 8x3mm neodymium magnets into each half. Remember to reverse the magnet polarity between the two sides. This is the same 2x3 pattern as most of my current fidgets. I have found this pattern to work very nicely.

For the best movement and fidgeting experience I highly recommend printing these on a textured build plate.

The magnets I used were purchased from Amazon, link below….

https://linktr.ee/mzmdigitaldesign

These were printed on a stock Bambu Lab X1C and P1S

0.4mm nozzle

0.12mm layer height

Infill: 30

I recommend using the settings I have saved in the attached 3mf file as I have found these settings to provide the nicest quality print.

Please tag me on TikTok so I can see your creations.

As always please let me know if you have any questions! Thank you!

Mike