KickFlip Magnetic Fidget - Leaf Deck - FILES (Patreon)

Its been a little bit since I shared a new KickFlip deck design so here you go. For all Bambu Studio users or anyone who can use a 3mf file,

Its been a little bit since I shared a new KickFlip deck design so here you go. For all Bambu Studio users or anyone who can use a 3mf file, I recommend using the attached 3mf file. For anyone who cannot use a 3mf file all of the stl files are located in the zip file attached.

If you use the attached 3mf file in bambu studio the printer will pause at layer 25, at which point you put the magnets into the decks. I have found it easiest to hold the magnets in a stack and put the stack into the hole and slide the stack off into the next hole. Place 8 magnets into one deck and flip the stack of magnets and repeat the process with 8 magnets in the second deck. Resume printing and the printer will print over top of the magnets and you will be ready to fidget as soon as the model is done printing.

If you have not printed a KickFlip deck yet and you are wondering about magnet placement please check out this post https://www.patreon.com/posts/kickflip-magnet-121228896?utm_medium=clipboard_copy&utm_source=copyLink&utm_campaign=postshare_creator&utm_content=join_link

There are 8 (8x3mm) Magnets embedded into each deck. The magnets can be purchased from Amazon using this link https://amzn.to/3V8lInO

ALL models INCLUDING the crate are printed with NO Support material.

These models were printed on stock Bambu Labs X1C or P1S printers. I use the 4 Color AMS system to print the models in color.

Filament: Eryone Yellow / Green Silk PLA https://a.co/d/1wKbeCf

Please let me know if you have any questions. Thank you!