Need your advice for silver PSU mount (Patreon)

Dear Patrons,

I am working on the PSU mounts and I thought about moving the silver PSU more on the back and use an M3 t-nuts directly on the v-slot (green arrow on the picture). This would apply to silver PSU only. The PSU will move back by 5-6mm only.

Advantages

• Simpler, no more part to print and assemble.
• Wires will be closer to the back of the v-slot (by 5-6mm) which will help a little for wiring.
• PSU a bit far away from the heated bed so less heat transmitted to it.

Disadvantage

• Potential miss-alignment issue.
• PSU plug is going to be a little bit more on the back, not sure if it can be an issue with enclosure.
• Screws will be slightly different between MK2S and MK3 but not a big deal.