Home Creators Posts Import Register Favorites Logout

Content

Here's what I used(l

Zippers for Spider-man cosplayers and other bodysuit costumes have forever been an issue. Whether it be the zipper being too long, the fabric being stretched, or simply just a result of the way the pattern was made.

Any of the mentioned situations can cause Norman Osborn level of waves across where the zipper was installed(Example below)

Now I have personally delt with this issue a few times but it was much more minor than this. I know for a fact the fabric was not stretched when sewing my zippers as I stabilized the fabric by putting painters tape near where I was going to sew

(PLEASE DONT SEW THROUGH PAINTERS TAPE)

So I can rule out uneven stretching or any similar issue.

@Sir_Goofs told me that Spider-Man and bodysuit patterns just tend to have a long back piece. Not that the backpiece is longer than the front but that it just is a long seam overall.

With that information I knew I had to find a solution as I was not willing to change my base digitally, especially since it is a standardized format for many of you now.

So what can we do??

My first thought was "Why is this bending in the first place" apart from the previous common issues mentioned.

I then decided that the zipper was to flexible for such a stretchy fabric and wanted to stabilize it somehow to stop the ripples being able to happen

I thought perhaps corset boning could be used for this as it adds structure to corsets.

I looked on amazon and saw two distinct types. Metal and plastic boning

Metal boning-Looks like metal cable of some sort, there were also o/chain shaped ones.

I figured this option could be sharp if not fully encased and also may be too stiff

Plastic boning- Comes in various sizes such as 12mm,10mm,8mm,6mm,etc. It is essentially a series of plastic rods connected with some sort of fabric mesh/weave. The type I ordered was "Sew-in" meaning you can sew through it.

I decided 6mm was most likely a perfect size

Here's what I tested

I first sewed with a zig zag (about width of 2, length of 2) on the boning along the back side of the zipper tape that was connected to the front of the suit, as this bends less than the back of the suit while putting it on.

I used a zipper foot to hold the boning to the tape, and put the higher edge of the zipper foot over the teeth to keep things aligned.

When putting on the suit the results showed for themselves!

However we were not out of the water quite yet! The boning was stabbing my armpit which was quite uncomfortable.

I was able to mend this by taking about 2 inches of the boning off of the top of the zipper. So the boning starts roughly 2 inches from the armpit

This helped immensely with the stabbing issue however next the boning was "poking out" of the side of the suit

this was easily fixed by bending the boning inwards towards myself as its quite posable. I think this may have been caused by the fact the boning came on a roll

googling this now, you are supposed to iron it before using it lol

The final result is very smooth and there are no more waves.

Files

Comments

Sebastian Ryder

I know this was only a experiment but could this technique possibly work to help stabilise a zipper that goes all the way around the waist like a belt?

_sensational_

I think that may be a bit more up in the air honestly. idk if it would make the suit harder to put on, and idk if it would even help. I’m sure something would change but idk if it would be good or bad. Could be worth a test! Zigzags are easy to seam rip