Home Creators Posts Import Register Favorites Logout

Content

STL Files Here 

Video Here 

Desktop Skee-Ball is not only a super fun desktop game, It's the best way to procrastinate. This is the most fun desktop game I've made so far, and it's definitely the coolest looking as well. It's also very aesthetic and can be printed in colors to match your setup. These make great gifts but can also be sold for a profit.

Components you'll need to order.  All of these should be on Amazon Prime. These are the exact same components as desktop golf.

1. The Balls: 1/4" Steel Ball Bearings (Amazon)

2. The Magnets: Small Round Magnets (Amazon)

3. The Tube: 3/8" ID, 1/2" OD PVC Clear Vinyl Tubing (Amazon)

--Assembly Instructions--

Everything goes together in an intuitive way. However, here are some instructions on assembly.

Machine

- Snap Bottom Cover onto Machine Base

- Snap Hole Board into Machine Base

- Snap Top Cover onto Machine Base

- Insert Clamps into sides of the Machines

- Screw screws into clamps and secure to desk

- Insert tube into hole on Bottom Cover

Launcher

- Install the 2 magnets into the slots as shown below

- Insert screw into Launcher, tighten onto desk

- Place the Hex Piece into the tee box hex hole

- Click the Spring onto the hex

- Insert Release lever into hole underneath the Launcher

- Cut Tube to length (some sag is fine) and insert into the tube hole. Start with the tube longer than needed and test to see if the ball has the correct speed. Cut tube shorter if more speed is needed

Files

Comments

Twisted Prints 3D

I love the fact that the parts you design these around can be used on multiple designs!!! Saves the hassle of having multiple parts laying around

Wyatt McLaws

I love this! I do not see any launcher files, are those reused from Golf? It looks like the spring/hammer part is different.

Ben Wyatt

Love this! Are you planning a version that doesn’t require the tube to return the ball?

Shawn

This is cool!

Garrett Waite

Is PETG required for the spring part? Or have you had success with PLA. I only ask cause from the photos it looks like PLA om the spring for every model beside the bowling spring.

Barry Beach

What are the angles on the cover and machine base? I'm not sure my printer can handle them without supports.

LayerusRex

OK, if I were wearing a hat it would be off to you sir. Your designs are PERFECT. I've made a variety of them now all for personal / family use - the Porthos plant, spinning pots, the cactus toothpick holder and more - and they have all been absolutely perfect. Your attention to detail and the tolerances you hit on your designs...wow. I'm printing this on a Prusa MK4 with a wide variety of filament from the dirt cheap (IIIDMax PLA+) to nice Hatchbox PETG and everything in between. Every piece and part has come off my print bed perfectly, and some of this stuff is really intricate. Thank you so much for this and all of your other fun prints! I haven't finished printing this yet, I've finished the machine & clamps and am now printing the launcher & spring. The design of the clamps as the rails and the fit of the big hex screws is soooo nice.