Home Creators Posts Import Register Favorites Logout

Content

STL Files Here

TikTok Video here

This spinning switch storage container is super fun, practical, and can now also be used as a travel case. This version has an included lid that can store into the base, so it's out of the way when you don't need it, but is right there to use as the lid when you're traveling.

I also improved the tolerances on this version to make it easier to assemble, made the peg stronger, and improved the magnet distances.

Components you'll need to order.

1. The Magnets: Small Round Magnets (Amazon) (same magnets as all other prints)

You'll need 22 magnets per spinner

2. Bearings: Fidget Spinner Bearings (Amazon)

You need just 1 bearing per spinner

3. Stick on Rubber Base (Optional): 58mm Anti-Slip Silicone (Amazon)

You need just 1 per spinner

How To Assemble Video Here

Files

Comments

MS Design

Can u please provide bom and links, because I need to change country on the Amazon app to see this articles

Boulevard

Do I need to reprint the top piece? Obviously I know ima have to print the new bottom and the cover piece

Jeremy

where is the lid file its not on there

Barry Beach

How easy would it be to translate the new tolerances to the other versions?

Chris McCumber

Good evening, I am having some difficulties with the strength and size of the print. When my print is complete and I start the assembly process for some reason the peg that goes into the bearing connecting the top to them bottom is extremely loose. Any ideas on how to fix that?

Chris McCumber

Also, as I try and make it a little tighter by adding a very small amount of tape it seems to work but it snaps at that bottom of the peg. Any advice on strengthening that as well, please.

Chris McCumber

I always follow your suggestions on the post so everything is 15% infill gyroid. So how much would you suggest to increase it to.

Aladin Isakovic

Have exactly the dimension with magnets and that hole is too big, they fly through and down again out

Connor Janssen

Assembled as shown! Is the bottom supposed to easily slide off or am I supposed to secure it somehow? Black center piece to base where the bearing connects