Home Creators Posts Import Register Favorites Logout

Videos

  • 568553769.mp4

Downloads

Content

A little update video on the Miata and other projects.

Files

Comments

Abhi Velaga

i vote new engine with AC, softer motor mounts, and that runs on normal pump fuel! cars are more fun when you can drive them as much as possible. i’m trying to build my supercharged miata to be as streetable as possible for that reason

FlyWay Air

Buy a stock 1.8, with a smaller turbo, then rebuild the 1.8 to make heaps of power

Gingium

1.8l use different parts for everything so I’d have to get a BUNCH of new parts. Not worth IMO. Stock engine 1.6 and 1.8 make the same power too

X-TASI

Lower compression pistons and get it back on 93 with the same turbo. Would be cheaper than buying a whole 1.6 (i hope) and would make your built motor streetable again

Gingium

Interesting idea. I think usually you need to machine the block when swapping pistons, which would make it more expensive. Could just send it and see what happens tho 😂

X-TASI

I think what matters most is cylinder wall condition. If they’re still in good shape then as long as your piston diameter and ring specs are good with your bore, it should be pretty straightforward swapping them out. If they’re in bad shape tho, then that would definitely warrant a trip to the machine shop

Luke W.

This was going to be my suggestion. No need to machine… do a “dingle ball” hone on the cylinders and new piston rings and you’re good.

Luke W.

Is the block over-bored…I don’t remember? If not, you could buy some OEM pistons, OEM rings, do the dingle ball hone and send it. If it is over-bored, depending on the bore, you can source some cheap aftermarket cast pistons as long as it’s not super over bored. Like if it’s only 0.020” over there are OEM style pistons in that size you can get cheap.

Gingium

It’s definitely over bored, I’d have to get a set of forged pistons or something for them to fit. Still cheaper than some other options

Luke W.

Honestly, if your sub 300whp you should be able to get away with OEM style cast pistons…if the tune is decent. A 200whp Miata street car is still hella fun and can be very reliable with cast pistons and forged rods.

Matthew Elmore

I got a couple blown 1.6s one state over. They are yours if you want them.

FlyWay Air

That is true, but the 1.8 can easier make more power, so it would be more future proofing, but I se your point

Riley8425

Hey I know you said you want to do a BEAMS swap but you should really look into doing a j32 swap… they are pretty affordable to do and you can easily get 300 crank hp out of one. You could definitely do it just by parting out your current setup.