Rally Miata AWD Swap - Finishing the Cage (Patreon)
Published:
2020-03-22 01:16:48
Imported:
2026-06
haven't archived this post yet. have a subscription? use the importer!
Content
One of the last steps before final assembly, wiring & interior: finishing the cage!
Added a slant bar connecting the corner of the main hoop to the opposite lower corner (helps support the main bar in the case of a roll over) then made door bars! I'm super happy with the way the door bars turned out. They hug the inside of the door super close so there is still a bunch a room in the interior. Tomorrow I'll be adding some bars connecting each of the door bars and tieing them into the door jam!
Once all is said and done this will be a 14 point roll cage!!! It's nice knowing I could drive this car off a cliff and survive lol.
Files
Previews only