Home Creators Posts Import Register Favorites Logout

Content

So the first video in “turbocharging the Honda Fit” has been done for a few days. Filmed AND edit, but I wanted to get this motor mount situation figured out for the video first before sharing it with you guys.

When I disassembled the car to install the clutch I discovered the factory front motor mount was completely torn apart. In I desire to upgrade it, I fabricated a custom mount using a polyurethane suspension bushing. Well… that was WAY too stiff. It pretty made the car seem like it had solid motor mounts. My second idea was to purchase a factory mount, and fill it with polyurethane sealant. One the sealant dries, it should stiffen up the factory mount quite a bit while still remaining flexible. The problem: I filled the motor mount 3 days ago and it’s still isn’t fully cured. Soooooo I’m going to give it another day or two and send it. Once that’s done, I’ll have the video for you guys! (Also nobody makes an upgrade for this motor mount otherwise I would’ve just purchased one)

Sorry for the delay!

Files

Comments

Ding Dong Drift

Try poking holes in it, let it cure, then fill the holes.

Gingium

I did consider this. Imma try the oven first lol

AJ Ortega

why not just buy another bushing for a similar application in a different car and fab a bracket designed around that?

Gingium

Didn’t know how to find one tbh

Jambles

Could just fab around a 4-link bushing from thorbros.com (or honestly wherever, just a good quality example) and if it seems too stiff, the poly inserts are standard sizes and you should be able to find a lower durometer without too much trouble.

Jambles

(also, since motor mounts aren't meant to rotate routinely, you wouldn't need the zerk fitting. Not something that will make a difference in this application either way but you can save a buck at least.)

Brian Kalter

You should design & start selling upgraded motor mount kits for Fits. Might be a market for them, since no one else makes them.