Welcome Pack! 🐸 Croaking Clickers (Patreon)

Riiiiiiibbiiit............ Ribbit, Ribbit, Ribbit!

Since apparently April is National Frog Month, and I'm kinda on an animal clicker kick right now, I thought it was only fitting that our next release be these adorable Croaking Clickers! I played with a few different eyes and faces and have included them all here for you! I hope you enjoy! 🐸

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with both the Kailh Bronze and Kailh White clickers but the White clickers are much nicer in my opinion. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process). A 7mm keyring file is included as well as a larger, 3.5mm diameter keyring hole to allow a beaded chain to be used!

This pack contains 4 fantastic frogy faces and 1 clicker base for a total of 4 designs! An open mouth, closed mouth, cute open mouth and closed open mouth. The base is provided with the standard keychain configurations, none, 7mm and 3.5 diameter keyring.

(all caps are saved as .3mf only)

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter: 0.33mm

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

NOTE: I've found the best way to get the most crisp details on the faces is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Red (tongue)

White (Eyes)

Black (Pupils/mouth/nose)

Everything else (face colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design.

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾