Apr '24 Exclusive: 🐺 Wolf Pack (Patreon)

🔒 Archived 07/09/24 - You can get this file from Cults3D or MyMiniFactory.

-------------------------------------------

I'm howling for today's release and for breaking 50 followers! Thank you all again for all your support.

After another animal request I set out with a new challenge of making a wolf clicker. After a few miserable failed attempts at making a "majestic" adult wolf face and "cute" baby wolf face, I am ecstatic about how these guys turned out!

I hope you all love my little clicky wolf pack as much as I do! 🐺

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with Kailh Bronze, White, Jade and White V2 clickers and the White clickers are my preferred option. I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process). A 7mm keyring file is included as well as a larger, 3.5mm diameter keyring hole to allow a beaded chain to be used!

This pack contains 5 wonderful wolf faces and 2 clicker bases for a total of 5 designs! There is a single face for the adult wolf and 4 faces for the babies, eyes/mouth open, eyes/mouth closed, eyes open mouth closed, eyes closed mouth open. I did save an 'Extra White' variant because I felt like the white wasn't bright enough on some of the faces so the extra white variants have a second, 0.2mm layer of white to really make the whites pop! The bases are provided with the standard keychain configurations, none, 7mm and 3.5 diameter keyring.

(all caps are saved as .3mf only)

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter: 0.33mm

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended)

NOTE: I've found the best way to get the most crisp details on the faces is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Red (ears/tongues)

White (Eyes/fur)

Black (Pupils/mouth/nose)

Everything else (face colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design.

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾