Supporter Exclusive: Pumpkin Poppers Multi-Pack! 🎃👻 (Patreon)

We knew with Halloween there would be some opportunity for a few 3D clicker models, and I initially added 'ghost in pumpkin' to the list of Halloween themed models! I just knew a little ghost peeking out of a pumpkin would make an adorable desk fidget for those stressful days at work! After some serious consulting with Nick to execute my vision, I am soooooo happy with how these Pumpkin Poppers turned out! 🎃👻

⚠️Please note: Because these caps are larger, they may be easier to pull out of the base than our flat caps. That being said, I personally would recommend using glue between the cap and the switch on this model to improve durability. We just add a dab of superglue to the plus of the key switch (clicky part). We created these as more of a decorative desk fidget than a keychain fidget, so did not add key chain holes. However, keychain holes are an approved mod that you are more than welcome to add yourself. We just couldn't agree on a location we thought worked!

Pumpkin Poppers Multi-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with Kailh Bronze, White, Jade and White V2 clickers and the White clickers are my preferred option. I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  There is no keychain option included on this model but keychain holes are an approved mod and can be accomplished in most modern slicers by adding a negative shape!

There are 5 unique pumpkin bases in this pack, and 4 unique ghost caps for a total of 20 unique Clicker Combinations!

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Pumpkin Poppers Multi-Pack can be found HERE!