September '24 Exclusive: Midnight Mayhem 🦇🕸️🕷️ (Patreon)

🔒 Archived 11/01/24 - You can get this file from Cults3D or MyMiniFactory.

-------------------------------------------

Hello! I am still on a Halloween Kick and have yet another fun release for today! Personally, if I see either of these midnight critters in person I tend to get as far away as possible, as quickly as possible, but we couldn't do Halloween without some bats and spiders. These little guys I might not even have to run away from because they are just soooo darn cute! At least my very biased self thinks so! We hope you enjoy these as much as we do! 🦇🕸️🕷️

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with Kailh Bronze, White, Jade and White V2 clickers and the White clickers are my preferred option. I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  A 7mm keyring file is included as well as a larger, 3.5mm diameter keyring hole to allow a beaded chain to be used!

There are 3 unique bases in this pack, an adult bat which has 2 cap options, a baby bat with 5 cap options and a spider web with 3 cap options for a total of 10 unique Clicker Designs! Each base comes in the standard 7mm, 3.5mm diameter and blank keychain configuration.

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Small Detail (Eyes, Mouth, Ears, Tongue, Web)

Everything else (Base Colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design.

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾