Welcome Pack: Witches Wares! 🧹☠️🔥 (Patreon)

FRIENDS!!! I am soooo excited for this Witches Wares, witchy themed pack I referred to yesterday! We have had a ton of request for witchy themed clickers so as the requests came in, I kept adding to the initial 'cauldron pack!' This pack has been so fun to design and add a few extra clickers along the way! I especially LOVE the little cauldrons.. especially the wooden base with skull & bone cap to add an extra spooky factor!! I hope you enjoy my Witches Wares!🧹☠️🔥

Witches Wares Multi-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with Kailh Bronze, White, Jade and White V2 clickers and the White clickers are my preferred option. I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  

This pack contains 1 unique broom base and one broom cap, 2 unique witch hat shapes, with 2 cap options each, and 4 unique cauldron base shapes with 3 cap options which are interchangeable. This comes out to a total of 17 total clicker possibilities in this pack! The broom and witch hat bases come in the standard 7mm, 3.5mm diameter and blank keychain configuration. The cauldron base comes in the 3.5mm and blank keychain configuration, but a 7mm jump ring can fit through the cauldron's handle!

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Hat Buckle (yellow)

Hat Strap (black)

Everything else (Base Colors)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design.

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Witches Wares Multi-Pack can be found HERE!