Supporter Exclusive: Kawaii Corner Collab - Bunnies & Baskets 🐰🥕🧺 (Patreon)

Today we have something a little different with this ADORABLE Collab we've done with Kawaii Corner (Caroline)! I've been loving Caroline's Kawaii style and creepy cute cryptids, so when the opportunity arose I was so excited to work with her on a clicky, Kawaii collab we could share with our supporters! Caroline designed this super cute bunny and basket and I turned it into a decorative clicker! Since we had a bit of a carrot theme going on with the basket, I decided it was the perfect opportunity to add a few carrot clickers to the mix! I hope you enjoy the mixing of styles this pack offers - I know I am loving how this pack turned out! 🐰🥕🧺

In addition to the clickers, Kawaii Corner is offering a non-clicky version of the bunny and basket as well, so if you are loving Kawaii Corner's style and thinking to yourself, this would be cute as a non-clicker, check out her Patreon or Thangs!

Bunnies & Baskets Multi-Pack can be found HERE!

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models feature a universal base design which has been tested with many keyboard switches and 99% of them work! I have an up to date list of verified clickers with links you can find HERE. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process).  

This pack contains 2 unique base shapes and 6 unique sets of caps. Raised variants are offered where able. There are no keychain holes in the bunny as it is quite tall and intended to be a decorative desk fidget. The carrot base comes in the standard 7mm, 3.5mm diameter and blank keychain configuration..

Photo Colors 🎨

Brown - Overture Brown

Beige - Polyterra Army Beige PLA

Pink - Polyterra Sakura Pink

Orange - Amolen PLA Basic Carrot Orange

Green - Elegoo Neon Green

Black - Overture Black

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter (Outer Wall): 0.33mm (recommended)

First Layer Extrusion Width (Initial Layer Line Width): 0.35mm (recommended)

Only one wall on first layer: True (recommended)

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

Orientation: Print the caps face down so you have a smooth surface for clicking! (recommended for flat)

NOTE: I've found the best way to get the most crisp details on these clickers is to start with the smallest details first and work up from there. Here is the order I recommend after LOTS of trial and error:

Small Detail (Eyes, Mouths, Dimples, etc)

Medium Detail (Carrot Details)

Everything Else (Base Details)

I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design (flat designs ONLY)

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾

Bunnies & Baskets Multi-Pack can be found HERE!