Welcome Pack: Emotional Clickers - Simple Pack (Patreon)

This is the SNEAK PEEK and SHOUTOUT to our very first Patron, DonumExMachina! We were originally going to release this later in the week but just couldn't contain our excitement! This is a small collection of some of my favorite, simple emojis and I think they turned out pretty well! You can also put a keychain on them and take them wherever you go! I hope you like them as much as I do! 😎

Like most of my designs, this is a clicky design that requires a mechanical keyboard switch to make the clicky part. These models have been tested with both the Kailh Bronze and Kailh White clickers but the White clickers are much nicer in my opinion. This design should be compatible with most MX style keyboard switches, however, the two metal contacts on the bottom of the switch must be clipped off flush (or folded over) to ensure the switch seats properly in the base (this is a destructive process). The keyring hole is sized for a 7mm split ring.

This pack contains 18 unique faces!

(all caps are saved as .stl and .3mf for your convenience)

3D Printing Settings:

Layer Height: 0.2mm (recommended)

External Perimeter: 0.33mm

Scale: 100% (Everything is modeled with tight tolerances and should not need to be resized)

NOTE: I've found the best way to get the most crisp details on the faces is to start with the smallest details first and work up from there. In this case, the whites in the eyes should print first followed by the black and finally the main body (yellow). I've also found hitting the print with a heat gun right before the main body color starts printing will eliminate any little strings that can cause blemishes on the final design. Some of the white details are very small and if you are having bed adhesion issues, you can always print them black and the face should still look good! 

⚠️WARNING⚠️ - This pack requires very good bed adhesion to ensure the best possible results for your finished clicker. It is recommended to clean your bed with soap and water before printing or whatever your specific printer manufacturer recommends for a deep bed clean!

Stay Pawsitive! 🐾