Home Creators Posts Import Register Favorites Logout

Content

Here are some of the additional parts (meant to be soldered by users) for the Vectatus prototype:

  • FQP30N06L - N-channel MOSFET (I'll use IRF3205 for the first prototype since I have it already, but the FQP30N06L is way better in terms of efficiency as it has much lower Vgs threshold voltage - this is especially useful for the input voltages below 5V)

  • LGT8F328P QFP32 package - main MCU for the project, development experience has been great so far. it works with Arduino, but I am using Platformio for this project as it is quite well structured

  • R020 (20mΩ) 1206 SMD resistors - for input and output current sensing

  • 4.7uH 14.9A 12x12mm SMD shield coupled inductor - coupled inductors for SEPIC converters (https://www.aliexpress.com/item/1005008281368331.html)

  • 100nF 0805 capacitor - decoupling capacitor for the MCU soldered on the back side of the board

I got a bit a firmware already done, with leds, buttons, cv mode and protections already in place.

Comments

kamilsss655 (Nunu)

Ohh and the switches are 3*4*2 mm SMD Switch 4 Pin which are popular on Aliexpress as single item or part of the kits.