Home Creators Posts Import Register Favorites Logout

Content

First ever Vectatus board have left the production line!

I've finished CV mode firmware implementation for Vectatus and tested it on prototype board. It worked well both in boost and SEPIC topologies.

Also finished soft-start implementation for CV mode.

While at it I've realized that the SEPIC topology along with input and output voltage, current sensing used in Vectatus will allow for it to use MPPT (https://en.wikipedia.org/wiki/Maximum_power_point_tracking) for charging cells via solar panels.

Here is a good write-up on the MPPT with SEPIC: https://www.ijser.org/researchpaper/MPPT-TECHNIQUE-USING-SEPIC-CONVERTER-TO-TRACK-MAXIMUM-POWER-POINT-FOR-PV-PANEL.pdf

Additionally I am looking into some niche/experimental modes like:

  • charging alkaline batteries - usually requires very slow charging to avoid temperature rise

  • reviving 12V car batteries (aka "Battery Desulfation") - usually requires low current charging ~200mA over couple of days

Comments

No comments found for this post.