Trash can with swing lid “Glitch” (Patreon)

A beautiful trash can suitable for your home, office and especially bathroom. The container can be used with or without the print-in-place swing lid. The shape is inspired by old videogames where resolution does sometimes did not fully load.

Included versions:

A: Regular

Body_regular: The body with 230mm height (default)

Body_regular_vasemode: the body to print in vase mode

Lid_regular: the Lid – print-in-place (default and recommended)

Lid_regular_seperated_1 and Lid_regular_seperated_2: Both parts separated – print them this way if your printer tends to mess up gaps - to join them just bend the ring a little and insert the lid

Size assembled: 210 x 192 x 255 mm

Volume: 5 Liters

B: Small

Body_small: The body

Body_small_vasemode: the body to print in vase mode

Lid_small: the Lid – print-in-place (default and recommended)

Lid_small_seperated_1 and Lid_small_seperated_2:  Both parts separated – print them this way if your printer tends to mess up gaps - to join them just bend the ring a little and insert the lid

Size assembled ca: 138 x 120 x 163 mm

Volume: 1 Liter

This is the V3

Print settings

Material usage regular: Body 250g; Lid 150g

Print time regular: Body 15h; Lid 10h

Material usage small: Body 100g; Lid 80g

Print time small: Body 6h; Lid 5h

Material: PLA

Print direction: stls are rotated correctly, check images

Support: none

Nozzle size: 0,4 mm

Line width: 0,4 mm

Layer height 0,2 mm

Outer walls: 3

Infill: 20%

Build plate adhesion type: none

Licensing

Individual purchases, free downloads and and all memberships besides the tiers that specifically allow for commercial use are for personal use only! Make sure to fully read and understand the License