April Model Release: Halfling Hill Home Dog Bag Dispenser (Patreon)

We are way too excited about this one!

Introducing our Halfling home inspired dog bag dispenser! The body is styled like a cozy little hillside door with flowers on the roof, and it is designed to be practical for everyday use. Dog walks deserve whimsy too!

This model is designed to be 3D printable with no supports, and we also included multi colour .3MF files so you can get that bright door and flower roof look straight off the build plate if you have an AMS or other multi material setup.

Key features

No supports required (FDM friendly, easy printing)

Multi colour .3MF files included with pre assigned colour regions

Secure twistable One Ring cap design

Extra thick construction to withstand everyday wear and tear on walks

What is included

You receive:

Hobbit home bag dispenser body

Ring cap

Multi colour .3MF project files (Bambu Studio and generic slicer formats)

Files for this month are provided to active Drake and Ancient Dragon patrons through Google Drive during the release month. Once the models are available on MyMiniFactory, you will receive a reward link so you can add them to your MyMiniFactory library.

Google drive link for this month's release:

https://drive.google.com/drive/folders/1BEPrlHybavtaIW3ZVXaLy6dLrGiM1hnW?usp=sharing

Printing notes

General FDM recommendations

Printer type: FDM

Material: PLA or PETG (PETG would be recommended to be the most durable)

Nozzle size: 0.4 mm

Layer height: around 0.2 mm

Infill: 10 to 20 percent gyroid (or your preferred pattern)

Supports: none required

Ring cap detail

The writing on the ring is quite fine, so for the cleanest results we recommend printing the Ring cap on a separate plate from the base.

In Bambu Studio, switch wall generation to Arachne mode to better capture the tiny lettering detail.

Multi colour printing

Load the included .3MF to access pre assigned colour regions

Keep our palette or swap colours to match your own vibe

Tier access and usage

Drake tier: Receives this model for personal use as part of this month’s pack.

Ancient Dragon tier: Receives the same files plus the right to sell physical 3D prints under the merchant license terms in our Patreon introduction post.

STL resale or sharing is not permitted. Credit to Curations By Kira is required when selling physical prints, and merchants must have an active Ancient Dragon subscription.

If you print one, we would love to see your colour combos and dog walk setups.