Home Creators Posts Import Register Favorites Logout

Content

The supported files of  these guys have been added to the archive.

Stay tuned, there's a lot of new minis coming out this week.


Have a great day!

Files

Comments

Damian

i usually find in this supported versions that there are few point that are not supported but they should be, do you find any problems when you print this versions? in the shokan 4 arms one finger wasnt supported

Cast n Play

We always test print the models before uploading the supported files. Also, the prints we post are using those files. The Shokan came out perfectly with all it's fingers. Did you lose any of them?

Damian

i wish i could upload a photo, the right down hand has the upper nail unsupported, im printing right now but i added a support there

Chris Rees

I just joined today and tried to set up the troll with the bone club in the Smash pose. I thought I saw some potential islands, so I ran the photon file through the Photon File Validator and it came up with a ton of unsupported islands in layers. It's nothing I can't fix myself, and I'm sure you know far better than I do what does/doesn't need to be supported, but do you usually run your files through the validator to verify that everything is supported? I'm new to resin printing, so I'm always worried about the unsupported islands either becoming flat artifacts or becoming little bits of cured resin floating around in my vat

Damian

I talked about that with alex and he was right, you can print it as it is, no problems, it will come perfect

Cast n Play

Although the prints came out fine, the supported files are not always perfect, and whenever we catch an error we fix it. Thanks for letting us know. I’ll give the supported file a second look. And correct them :)